Rigging Design
Spreader Beams are a very versatile solution for multiple lifting requirements. From 2 points of lift, to 4, to 6 or 8, as long as you have the head height available (distance between the hook and the load) then a spreader beam system is a cost effective and easily accessible lifting solution.
Britlift can design you a rigging system and supply any chain/wire rope/synthetic slings, connectors, shackles, hooks, etc.
Single Spreader
2 POINTS OF LIFT
This is the most common use of a spreader beam. Custom spec slings are available within a few days.
Single Spreader (Two Leg)
4 POINTS OF LIFT
Utilising 2x two leg chain slings you can lift from 4 points using a single spreader beam.
One Over Two
4 POINTS OF LIFT
This is commonly referred to as a ‘one over two’. This system gives 4 points of lift when the load cannot accept angled slings.
One Over Two Inline
4 POINTS OF LIFT
This is commonly referred to as a ‘one over two inline’. This system could be used for lifting prefab slabs or piping/bar.
One Over One Inline
3 POINTS OF LIFT
By utilising two leg slings this 3 point system could easily become a 6 point system where the load can accept an angled connection.
One Over Three
6 POINTS OF LIFT
Commonly referred to as a ‘one over three’. This system gives 6 points of lift when the load cannot accept an angled connection.
ONE OVER FOUR
1 OVER 3 LIFTING BEAM ASSEMBLY
1 OVER 4 LIFTING BEAM ASSEMBLY
Looking for something different?
Britlift can design and manufacture any below-the-hook lifting system to suit any application and environment.
The best solution for your lift could well be something you haven’t considered. Get in touch and let us do the thinking for you, it’s what we are good at.
Enquiries
Please fill out the below contact form and include any additional comments you feel are important for us to know.
Please include the weight being lifted, length required, type of top and bottom lifting points (distances if applicable) and any special standards or specifications.
